2 to 3 weeks of beautiful nails with a deep color and beautiful shine!
Apply Bluesky Gellak/Polish in 6 steps:
To prevent bubbles or wrinkling of the Gellak, it is important to apply each layer thinly.
Remove Bluesky Gellak
Method Blossom Gellak with Blossom White Base
1: Apply base coat, cure in UV or LED lamp 2: Apply Blossom White base, cure in UV or LED lamp 3: Apply a second coat of Blossom White, do not cure 4: Make a creation with a nail art brush, e.g. a rose with the Blossom gel, cure in UV or LED lamp 5: Apply the Top coat, cure in UV or LED lamp
Note: White Color Blossom needs the Blossom Clear Base: base coat + normal black (or other color)
+ blossom clear base + blossom white + top coat.
This can be used to lengthen or strengthen the nails. Pre-treatment - disinfect hands with skin disinfectant or wash hands with soap - file the nails to the desired length, gently push the cuticles back with a cuticle pusher - clean the nail plate with alcohol 70% - have the Gel brush, an orange woodstick or goat's leg and a small bowl of alcohol ready
Renew with tips - apply a thin layer of Base Coat to the hard for 30 seconds under the lamp - grab a tip and apply the Gum Gel to the inside of the tip with an orange woodstick or cuticle pusher - dip the Gel Brush in the alcohol and spread the Gum Gel evenly over the tip - press the tip firmly on the nail plate so that no air gets under it - remove any remnants of Gum Gel with the Gel Brush - Cure under the lamp for 1 minute - pry the tip off the nail - possibly file the nail wall or nail tip - further finish the nails with a Top Coat or paint with a Gellak
If the natural nails are long enough, but a bit thin or limp, follow these steps: - apply a thin layer of Base Coat and cure it under the lamp for 30 seconds - apply a ball of Gum Gel on the middle of the nail - moisten the Gel brush with alcohol - spread the Gum Gel evenly over the nail - Cure under the lamp for 1 minute - possibly file some at the nail wall or nail end - finish the nails with Top Coat or a Gellak
Hard Gel degrease nails with 70% alcohol and allow to dry. - apply a thin layer of Base Coat and cure it under the lamp for 30 seconds - apply a thin layer of Hard Gel and cure it under the lamp for 1 minute - possibly you can apply a second layer of Hard Gel and cure it for 1 minute as well - apply a thin layer of Top Coat and cure it under the lamp for 30 seconds - remove the adhesive layer with alcohol if necessary You can also put the Hard Gel over the Gellak instead of under it.
- apply the Base Coat and cure it under a lamp for 30 seconds - apply two coats of color and cure them individually. - apply the Cat Eye Gellak, hold the magnet just above the nail for 20 seconds and cure it under the lamp (the position of the magnet determines the direction of the Cat Eye) - apply the Top Coat - remove any adhesive layer with alcohol
Builder Gel Natural Builder Gel (strengthening the nails) - apply a thin layer of base coat - apply a thin layer of Builder Gel (1 min curing) - apply a second coat of Builder Gel (1 min curing) - apply a thin layer of Top Coat - remove the adhesive layer with alcohol
Builder Gel with Template - apply a thin layer of Base Coat - place a template tightly against the nail - apply a layer of Builder gel and cure it for 1 min - apply a second layer and cure for 1 min (after this you can remove the stencil) - file on top of the nail with a 180 grit the nail smooth - file to the desired length - apply a layer of Top Coat - remove any adhesive layer